REDUCING TUBES
By using reducing tubes, the spindle bore of the CNC lathe can be adapted to the material diameter. This can prevent imbalance and vibration caused by unguided bar material, which can otherwise cause dimensional inaccuracy and negative impacts on the workpiece clamping. Well-guided bar material reduces spindle bearing wear and increases the service life of the cutting tools.
DRAW TUBES
Draw tubes are a component of the clamping system and are installed in the spindle of the lathe. Draw-in collets are screwed with their thread into the draw tubes. The workpiece is clamped by pulling the draw-in collet into the collet sleeve.
OPTION LONG PARTS
Long workpieces cannot be removed in the machine room. The long parts option allows the workpieces to be removed through the sub spindle of the machine.
COLLET SLEEVES
Collet sleeves are a part of the spindle in the machine. There are no limits to customer-specific requirements, as collet sleeves can be manufactured according to drawings as well as samples.
PRESSURE SLEEVES
Pressure sleeves are an important part of the clamping system and are installed in the spindle of the CNC lathe.
They can be manufactured in different versions. For overgrip collets the taper angle of the pressure sleeve can be adjusted. Used or worn pressure sleeves can be reground or reworked within shortest time. Another possibility is to reduce the pressure sleeves, so it is possible to produce on the same machine with a smaller type of collet. There are no customer-specific limits, as pressure sleeves can be manufactured according to drawings as well as samples.
COLLET SPRINGS
Collet springs are installed in pressure sleeves and are an important part of the clamping system.
CAP NUTS
Cap nuts are used as a stop for the collets and are screwed onto the spindle of the CNC lathe. They can be manufactured according to drawings as well as samples.